26 gauge steel
The common choice for homes, with a good balance of cost and stiffness.
Metal roofing
5V crimp is the old Florida metal roof, the one you still see on cracker houses around Lake County, and it remains one of the most affordable metal options for an Orlando home.

We install 5V over a solid deck with underlayment rather than over open purlins on homes, which gives a quieter roof and a second line of defense if a washer ever dries out. Typical cost in Orlando runs $8.35 to $12.60 per sq ft installed with tear-off, and the roof line answers 24/7 at (407) 783-0064.
Each 5V sheet has five V-shaped ribs, and the sheets overlap at the side rib and screw down through the flat. Because the screws are exposed, the install details matter more than the panel itself: screw spacing, the washer type, and how the laps are sealed decide whether the roof stays tight through hurricane season.
It is a strong choice for farmhouse style homes, outbuildings and anyone who wants the look of a classic Florida roof without the cost of standing seam.
Step by step
We confirm pitch and deck condition, since 5V works best at 3/12 and steeper.
Synthetic underlayment, drip edge and eave closure strips go on first.
Sheets go on square to the eave with sealed side laps and fastener rows on a set pattern.
Ridge cap and foam closures finish the roof so wind-driven rain cannot blow under the ribs.
Options
The common choice for homes, with a good balance of cost and stiffness.
Heavier sheet for more dent resistance and longer spans.
Will not rust, at a higher price, for homes close to brackish water.
Typical 5v crimp metal roofing cost in Orlando: per sq ft installed with tear-off. Final price depends on roof size, pitch, access and what we find under the old roofing.

Plan on looking at the fasteners every few years and replacing washers in the 15 to 20 year range. It is a routine visit, not a re-roof.
When it is fastened to the pattern the panel was tested for and set over a solid deck, 5V holds up well. Most failures we see come from wrong screw spacing.
We tear off on homes. It lets us see the deck, and it keeps the roof eligible for a clean inspection when the insurer asks.
Related work
Standing seam is the metal roof most Orlando homeowners picture: smooth panels, raised seams, and no exposed screws for the sun and rain to work on.
Standing Seam Metal Roofing detailsR-panel and PBR metal roofs cover a lot of square footage for the money, which is why they are on so many shops, barns and commercial buildings around Orange and Lake County.
R-Panel Metal Roofing detailsA metal roof replacement takes off what is up there now, shingle, tile or old metal, and puts down a new panel system built for Central Florida weather.
Metal Roof Replacement detailsStone-coated steel gives you the look of shingle, shake or barrel tile with the weight and wind resistance of a steel roof.
Stone-Coated Steel Roofing detailsReal roofers answer 24/7, and we come out to Orlando and the nearby cities every day of the week.